Sequential with 4 relay outputs. For each impulse received, the module will advance by one output, connecting it and disconnecting the previous one at the same time. After connecting the last, the process restarts.
The I-57 module is a 8 relay outputs that you can configure to go on or go back. With each received impulse, it will connect an output disconnecting the previous one. Also and according to the configuration, it will successively connect the outputs.
The I-57 module is a 8 relay outputs that you can configure to go on or go back. With each received impulse, it will connect an output disconnecting the previous one. Also and according to the configuration, it will successively connect the outputs.
The I-57 module is a 8 relay outputs that you can configure to go on or go back. With each received impulse, it will connect an output disconnecting the previous one. Also and according to the configuration, it will successively connect the outputs.
Level detector with relay output. When the probe included with the module enters in contact with the liquid, the output is activated and remains in this state until the liquid is no longer in contact with it. Includes sensitivity adjustment, LED indicator and P. P.
Automatic Check for wells or tanks, with relay output. Has two control modes: wells or tanks. In both modes the circuit maintains between the minimum and maximum levels of water, activating the output accordingly.
Automatic detection of voltage decrease. By placing them in parallel with the device to be checked, when the voltage goes below the preset level, the modules activate a buzzer, producing a warning signal.
Automatic detection of voltage decrease. By placing them in parallel with the device to be checked, when the voltage goes below the preset level, the modules activate a buzzer, producing a warning signal.
Automatic detection of voltage increases. By placing them in parallel with the device to be checked, when the voltage goes above the preset level, the modules activate a buzzer, producing a warning signal.
The I-76 can be configured as ORor NOR door, and the I-77 module as AND or NAND door. Regarding the two logical signals TTL and CMOS, modules will do the corresponding operation, connecting the incorporated relay output when the result will be a logical ?1?.
The I-76 can be configured as ORor NOR door, and the I-77 module as ANDor NAND door. Regarding the two logical signals TTL and CMOS, modules will do the corresponding operation, connecting the incorporated relay output when the result will be a logical ?1?.
Thermostat with output to relay. When the temperature drops 0.5º C. below the set temperature, it activates the output, disconnecting it when the temperature increases with respect to the set temperature by 0.5º C.
Thermostat with output to relay, 60 to 150°C. When the temperature drops 0.5º C. below the set temperature, it activates the output, disconnecting it when the temperature increases with respect to the set temperature by 0.5º C.
The circuit's acoustic warning will sound and alarm whenever the temperature increases by 1° C from the preset temperature. The alarm will cease when the temperature drops with respect to the preset temperature.
Automatic scale with relay, which accepts any type of load. Using impulse injection for each one, the model alternatively connects or disconnects the output in a stop and go sequence.
Electronic traffic light automatism. It allows the natural operating of traffic light, connecting sequentially outputs corresponding to the green, orange and red lights.